Alarm SAF RMBE Series Manual de Instruções descarregar pdf (Página 4)

Factory

Default Settings

SETPOINT 100 °F (37.8 °C)

AUTOTUNE ONCE

PROPORTIONAL BAND 24

RATE 7

DEVIATION ALARMS +/- 30 °F (+/- 17°C)

JUMPERS

JP1 SOFT START

JP2 SENSOR

JP3 CENTIGRADE / FAHRENHEIT

Jumper

Selections

Installation

Set jumper configuration to desired operation (see jumper table). To install

the controller in a mainframe, release the locking device on the lower edge of

the unit by pulling the plunger gently away from the panel. NOTE: For CE

units use appropriate tool to remove locking screw. Align the upper and lower

edges of the controller printed circuit board with the respective card guides

on the mainframe and slide the unit all the way into the mainframe until the

rear connector is completely engaged. Lock the controller into the frame by

depressing the plunger on the locking device.

1 2 3 4 5 6 7 8 9 10

Sem comentários

Alarm SAF RMBE Series Manual de Instruções Página 4